Tolerance - Cone Features

Up

Back

 

Tol. Home

 
 

Site Map

 

helmel.com

Introduction

Geomet applies tolerance in either Linear and True Position, including RFS, MMC and LMC when applicable. To understand the basics of tolerance, please refer to Introduction to Tolerance in Geomet.

Cone Features

Tolerance of Cones is possible in Cartesian and in either Linear, RFS, MMC and LMC formats.

ConeTol.jpg (24144 bytes) ConePosTol.jpg (20715 bytes)
figure 1, Bilateral Tolerance of Cones figure 2, Positional Tolerance of Cones

To activate the tolerance tool  see Working with Geomet Tolerance Windows

Figure 1 shows the Cartesian Bilateral Tolerance formats. To better understand how these formats are used and interpreted, refer to Introduction to Tolerance.

Figures 2 show2 Cartesian Positional Tolerance formats. To better understand how these formats are used and interpreted, refer to Introduction to Tolerance. Circles may also utilize Datum Bonus Tolerance when established in the current PCS.


Tolerance State On / Off, Tolerance Format, Process Control Tolerance, Out-of-Tolerance Flash Message