Offset Line

Up

Back

 
 
 

Site Map

 

helmel.com

Command Activation


 
  Construct→Construct an Offset Line  
Keyboard Main Menu Toolbar

Introduction

An Offset Line is a constructed line parallel to an existing measured or constructed 2D Line. The resulting Line can be used in constructions such as Part Coordinate System Alignments.

Creating an Offset Line

To build an Offset Line, start by first identifying in your part inspection one measured or constructed 2D Line.  Highlight the Line and choose from the main drop down menus [Construct→Construct an Offset Line].

figure 1, Offset Line Data Entry

Should Geomet not be able to identify the highlighted feature as a compatible Line, or more than one feature is selected, Geomet will display a warning. Geomet also validates that the highlighted Line is in the current Part Coordinate System.

Entering Nominal Offset Data

Enter to required nominal offset value. This value is sign sensitive to direct the Offset Tool which side of the reference line the new line should be created. Upon acceptance of the nominal offset value, Geomet will create a new 2D Line.