Tolerance - Ellipse Features

Up

Back

 

Tol. Home

 
 

Site Map

 

helmel.com
       
  6.66.011.001   All Geomet Levels 
       

Introduction

Geomet applies tolerance to Ellipse features using Linear or RFS True Position formats. To understand the basics of tolerance, please refer to Introduction to Tolerance in Geomet.

2D Ellipse Features

Tolerance of Ellipse is possible in either Cartesian or Polar and in RFS GDT format.

Ellipse Tolerance - BiLateral Ellipse BiLateral Polar
figure 1, Bilateral Cartesian figure 2, Bilateral Polar
GDT Ellipse Tolerance Polar GDT Ellipse Tol
figure 3, Positional Cartesian figure 4, Positional Polar

To activate the tolerance tool  see Working with Geomet Tolerance Windows

Figures 1 and 2 show Bilateral Tolerance on Cartesian and Polar formats respectively. To better understand how these formats are used and interpreted, refer to Introduction to Tolerance.

Figures 3 and 4 show Positional Tolerance on Cartesian and Polar formats respectively. To better understand how these formats are used and interpreted, refer to Introduction to Tolerance.


Tolerance State On / Off, Tolerance Format, Process Control Tolerance, Out-of-Tolerance Flash Message