Tolerance - Slot / Web

Up

Back

 

Tol. Home

 
 

Site Map

 

helmel.com

Introduction

Geomet applies tolerance to Slot/Web features which is limited to Bilateral / Linear. To understand the basics of tolerance, please refer to Introduction to Tolerance in Geomet.

Slot/Web Features

Tolerance of Slot/Web features is limited to Cartesian / Linear. The value reported by a Slot/Web is where the intersection with a single PCS axis takes place and is considered 1 dimensional. Therefore only bilateral tolerance inputs are allowed.

SlotWebTol.jpg (16720 bytes)
figure 1, Slot/Web Tolerance figure 2, Slot/Web GDT Tolerance

To activate the tolerance tool  see Working with Geomet Tolerance Windows

Figure 1  shows the Slot/Web Tolerance dialog which allow nominal entered data for position and corresponding width. To better understand how these formats are used and interpreted, refer to Introduction to Tolerance.


Tolerance State On / Off, Tolerance Format, Process Control Tolerance