Tolerance - Oval / Slot

Up

Back

 

Tol. Home

 
 

Site Map

 

helmel.com

Introduction

Geomet applies tolerance to an Oval-Slot features which is limited to Bilateral / Linear. To understand the basics of tolerance, please refer to Introduction to Tolerance in Geomet.

Oval-Slot Features

Tolerance of an Oval-Slot features is limited to Cartesian / Linear. The values reported by a Oval-Slot is the center 2 dimensional location, effective width and length.

OvalSlotTol1.jpg (20260 bytes)
figure 1, Oval-Slot Tolerance

To activate the tolerance tool  see Working with Geomet Tolerance Windows

Figure 1  shows the Oval-Slot Tolerance dialog where the nominal and upper / lower tolerance data can be entered for position, width and length. To better understand how these formats are used and interpreted, refer to Introduction to Tolerance.


Tolerance State On / Off, Tolerance Format, Process Control Tolerance