|
|
|
Introduction
Geomet applies tolerance in either Linear and True Position, including RFS, MMC and LMC
when applicable. To understand the basics of tolerance, please refer to
Introduction to Tolerancing in Geomet.
2D Circle Features
Tolerancing of Circles is possible in either
Cartesian or Polar and in either
Linear, RFS, MMC and LMC formats.
 |
 |
| figure 1, Bilateral Cartesian |
figure 2, Bilateral Polar |
|
|
 |
 |
| figure 3, Positional Cartesian |
figure 4, Positional Polar |
To activate the tolerance tool see
Working with Geomet Tolerance
Windows
Figures 1 and 2 show Bilateral Tolerance on Cartesian and Polar formats respectively.
To better understand how these formats are
used
and
interpreted, refer
to Introduction to Tolerancing.
Figures 3 and 4 show Positional Tolerance on Cartesian and Polar formats respectively.
To better understand how these formats are
used and interpreted, refer to
Introduction to Tolerance. Circles may also utilize
Datum Bonus Tolerance when established in the
current PCS.
Related Procedures:
Tolerance State On / Off,
Tolerance Format,
Process Control Tolerance,
Out-of-Tolerance Flash
Message
|
| |
|
|
